• Sign In
  • 0 items
  • Search
Welcome Guest! Please login to enable all features.



darcia1628987417 Offline
#1 Posted : Friday, November 09, 2012 9:58:09 PM(UTC)

Rank: Newbie

Groups: Registered
Joined: 11/9/2012(UTC)
Posts: 1

I am trying to cut 5 circles on 12x12 paper, I have it set up in an "X" shape. After a few pages were cut the machine is now cutting from the bottom left circle across whole page to the bottom right circle.

I've tried powering critcut off and restarting, didn't help. This is a new machine and mat.

Dragonfly50 Offline
#2 Posted : Friday, November 09, 2012 10:27:41 PM(UTC)

Rank: Advanced Member

Groups: Registered
Joined: 5/3/2011(UTC)
Posts: 2,482
United States

Thanks: 1238 times
Was thanked: 1223 time(s) in 729 post(s)
When mine acted up I did a reset. I'm trying to locate the reset instructions for you now.
Be back soon. Which machine do you have?

Here are the reset instructions for the Expression I copied from another post.
Hope you can get your machine up and running real soon.

1-Turn on your machine with no cartridge loaded.
2-Rolls all the grey dials down to lowest setting.
3-Open up the front where the blade housing sits, use the black arms, with the
screw to pull that entire unit along its track over to the other side
Of the machine.
4-Over where that unit usually sits, if you reach back there with your fingers, you’ll
feel a red button sticking out.
Push and hold down that button for 5 seconds, counting to 5 slowly. Then let go.
5-Use the black arms to move that unit back into its place where it usually sits.
6-Next you are going to roll all the grey dials all the way up and all the way down 3 times,
so three times total for EACH dial-doing 3 cycles of each up & down (may do 1 at a time)
7-Now press the CUT button
8-Turn the machine off
9-Let your machine sit for a FULL 45 min to an hour
10-After that full time passes, load a cartridge on, turn on your machine and try a
practice cut of something simple.

Edited by user Friday, November 09, 2012 10:45:29 PM(UTC)  | Reason: add info

Users browsing this topic
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF | YAF © 2003-2015, Yet Another Forum.NET
This page was generated in 0.774 seconds.