• Sign In
  • 0 items
  • Search
Welcome Guest! Please login to enable all features.



winzenried884dad0dad Offline
#1 Posted : Monday, February 04, 2013 6:56:21 PM(UTC)

Rank: Newbie

Groups: Registered
Joined: 2/4/2013(UTC)
Posts: 1

I have gone through heck trying to get my cricut(Circ- as I have named it) to work. Initially it was telling me that my ink cartridges were not installed. So I finally got past that part, and well.. i went through the printing callibration. Then the next step was cutting, Circ took in the mat, and it just came out of the back, rather than pulling back in to cut.. what the heck is going on!!??? :(
Khrista Offline
#2 Posted : Tuesday, February 05, 2013 7:23:37 PM(UTC)

Rank: Advanced Member

Medals: Cricut Circle Member: Member of the Cricut Circle

Groups: Registered, Circle Member
Joined: 5/12/2010(UTC)
Posts: 5,350
United States
Location: Southwest Washington State

Thanks: 1450 times
Was thanked: 2517 time(s) in 1401 post(s)
Make sure you haven't accidently covered up any black lines around the edges. Try putting the mat in the reverse direction. If you are using Cricut Craft Room, odds is that is the problem so try the machine as stand alone and see if it doesz the same thing if you're using CCR. Try a different mat (sometimes a scratch etc. can cause it to do that).

Users browsing this topic
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF | YAF © 2003-2015, Yet Another Forum.NET
This page was generated in 0.696 seconds.