• Sign In
  • 0 items
  • Search
Welcome Guest! Please login to enable all features.



sportykidsbug Offline
#1 Posted : Sunday, January 27, 2013 12:26:18 PM(UTC)

Rank: Advanced Member

Groups: Registered
Joined: 6/15/2010(UTC)
Posts: 114
Location: Michigan, MQ p. 16 #453

Thanks: 25 times
Was thanked: 63 time(s) in 51 post(s)
I've had my trusty old Cricut original for quite a number of years now and have been super-hesitant to do anything to it. Today I finally bit the bullet and tried to connect to the Craft Room. With all the comments on the board regarding problems with each of the machines, my anxiety level was pretty high -- but lo and behold, SUCCESS!!!

I couldn't have been more thrilled -- the software update went smoothly, I plugged in a cartridge and the image cut quickly and cleanly. All in all it took 15 minutes tops from the installation of the firmware update until the mat was unloaded with my first cut image. I am super excited to continue to use the craft room. I think I'll knock on wood just in case.Flapper
Users browsing this topic
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF | YAF © 2003-2015, Yet Another Forum.NET
This page was generated in 0.437 seconds.