Cricut® Project Center



Trick or Treat Banner


profile
Design by: MelodyLane (50 Projects)
Project skill level: moderate
Project time: 2 hours to 3 hours
Project tags: Home Décor/Accents Wall Décor/Wreaths/Banners Halloween Party Decorations/Favors Holiday Cards Seasonal Layouts Seasonal Cards Holiday Décor

Scary Halloween Banner using the bloody font

CRICUT ®: WHAT WAS USED

OTHER MATERIALS NEEDED

  • glossy accents
  • ribbon
  • spiderweb stamp
  • adhesive
  • card stock

Project Cut Files

STEP-BY-STEP How-TO INSTRUCTIONS

Download cut file for CCR I added lots of spiders in cut file and I will be hanging spiders from banner but have not done that yet. I show full directions in video but first you cut the letters out in red cardstock and then cover letters with Glossy Accents and let dry, move letters around a little while drying so they do not stick the surface you have them on, I used a straight pin to do that with.
After everything is cut stamp the black paper with a spiderweb stamp using grey, silver or white stamp, I think I used white.
Put the orange layer on after you stamped web. Apply the other cut outs and I laid them all on the table upside down and back wards, Put ribbon laying across the back. I cut 1"x12" stripe of black paper , ran it through my X xyron and then cut it into squares and stuck it over the ribbon. You can see that in video. I added the ghost with the black layer under the ribbon and the white layer on top of ribbon.

Step 1

Download cut file for CCR I added lots of spiders in cut file and I will be hanging spiders from banner but have not done that yet. I show full directions in video but first you cut the letters out in red cardstock and then cover letters with Glossy Accents and let dry, move letters around a little while drying so they do not stick the surface you have them on, I used a straight pin to do that with.

Step 2

After everything is cut stamp the black paper with a spiderweb stamp using grey, silver or white stamp, I think I used white.

Step 3

Put the orange layer on after you stamped web. Apply the other cut outs and I laid them all on the table upside down and back wards, Put ribbon laying across the back. I cut 1"x12" stripe of black paper , ran it through my X xyron and then cut it into squares and stuck it over the ribbon. You can see that in video. I added the ghost with the black layer under the ribbon and the white layer on top of ribbon.

Awards
See available awards

SHOWCASED - A FEATURED PROJECT
SHOWCASED - A FEATURED PROJECT
PRIZED - PROJECT FAVED 25+ TIMES
PRIZED - PROJECT FAVED 25+ TIMES
CELEBRATED - PROJECT FAVED 50+ TIMES
CELEBRATED - PROJECT FAVED 50+ TIMES
  • PRIZED - PROJECT FAVED 25+ TIMES

Related Projects

COMMENTS

Add your comments